and
Adjustment
3. Jogger fences [C] (
x 1 each)
4. Left half of table [D] (
x 2)
The front screw is a shoulder screw. Insert the screws in the correct holes when
re-attaching.
To avoid breaking the tabs under the left edge of the table, pull the table to the right to
disengage the tabs and then remove.
5. Inverter exit sensor [E] (
x 1, x 1, x 1)
6. Transport sensor 1 [F] (
x 1, x 1)
7. Transport sensor 2 [G] (
x 1, x 1)
To Next Page
Loading...
