Electrical Components: Main 2
SM 67 D454/D615
Multi-Folding
Unit
D454/D615
6. Tension brackets [A] ( x 1 each/ front: 4, rear: 4)
There are two types of tension brackets at the crease roller area. The difference
between these brackets is the number of screw holes ([A]: one hole, [B]: two holes).
Attach a bracket [A] with one hole to the crease roller frame with one hole.
Attach a bracket [B] with two holes to the crease roller frame with two holes.
7. Magnet attachment bracket [A] ( x 1)
To Next Page
Loading...
