Replacement and Adjustment
D454/D615 92 SM
Table Key
You must refer to the "Skew Correction Reference Diagrams". The following abbreviations
are used in the table above.
Term What It Means
F Long Front measurement of L1, L2, or L3 is longer than Rear..
F Short Front measurement of L1, L2, or L3 is shorter than Rear..
S1, S2, S3
Refers to Stopper 1, Stopper 2, Stopper. In the diagrams these are
annotated as: {, , } respectively.
Raise F
Raise the front end of the stopper fence. For more, see below.
Lower F
Lower the front end of the stopper fence. For more, see below.
Example: FM1 (Z-fold)
First, compare the L2 measurements.
In this example, imagine that L2 is longer at the front than at the rear.
Look at the table, in the row for FM1, and the column for L2.
‘F Long’ means Front measurement longer than Rear
‘F Short’ means Rear measurement longer than Front
L2 is longer at the front, so we have an ‘F Long’ situation.
Then look at the next line, below ‘F Long’. It says ‘Lower F on S2’.
To Next Page
Loading...
