and
Adjustment
5. Position the 1st scanner [A] so that the holes are aligned, and insert the positioning pins [B]
(x4).
6. Position the 2nd scanner [C] so that its holes are aligned, and insert the positioning pins [D].
7. Attach the lock bracket [E] to fasten the wire to the 1st scanner.
8. Tighten the screw of the tension bracket.
9. Attach the pulley and tighten its lock screw.
10. Remove the positioning pins (x4).
11. Remove the tape from the pulley.
12. Slowly push the scanner left and right to confirm that the wires are engaged correctly. The 1st
and 2nd scanners should move smoothly.
To Next Page
Loading...
