Ricoh D131 - Page 502

SC500: Feed, Transport, Duplex, and Fusing
SM Appendix 2-35 D131/D132/D133
Appendix:
Service Call
Conditions
SC559 A
Fusing jam: 3 counts
At the fusing exit sensor the paper was detected late for three pulse
counts (lag error), and SP1159 was on.
 If this SC occurs, the machine cannot be used until the service
technician cancels the SC code.
 This SC occurs only if SP1159 has been set to "1" (On).
(Default: 0 (Off)).
SC569 D
Fusing pressure release motor error
During copying, the HP sensor could not detect the actuator, tried
again 3 times and could not detect.
 Motor lock because of too much load
 Motor driver defective
 HP sensor defective, disconnected, connector defective,
harness damaged
SC590-00 D
Toner collection motor error
The toner collection motor sensor output does not change for 3 s
while the toner collection motor is on.
 Motor lock due to obstruction
 Motor driver board defective
 Motor connection loose, defective
 Toner collection motor sensor disconnected, sensor defective
 Rotational transmission shaft (dia. x 30) missing