Ricoh D131 - Page 539

SC800: Overall System
D131/D132/D133 2-72 SM Appendix
SC820 D
0008 Self-diagnostic Error: CPU: System Call Exception GW
0612 Self-diagnostic Error: CPU: ASIC Interrupt Error GW
 System program defective
 Controller board defective
 Optional board defective
 Replace controller firmware
Note: For more details about this SC code error, execute SP5990 to print
an SMC report so you can read the error code. The error code is not
displayed on the operation panel.
 For more details about this SC code error, execute SP5990 to print an SMC report so you
can read the error code. The error code is not displayed on the operation panel.
SC821 D Self-diagnostics error: ASIC GW
[0B00]
ASIC register check error
A write-verify check occurred in the ASIC.
 ASIC device
 Controller board defective
[0B06]
ASIC detection error
The I/O ASIC for system control was not detected.
 Defective ASIC
 Defective North Bridge and PCII/F
 Controller board defective
 For more details about this SC code error, execute SP5990 to print an SMC report so you
can read the error code. The error code is not displayed on the operation panel.