Ricoh D131 - Page 562

SC900: Miscellaneous
SM Appendix 2-95 D131/D132/D133
Appendix:
Service Call
Conditions
SC964 D
Printer ready error
The print ready signal is not generated for more than 17 seconds after
the IPU received the print start signal.
 Software defective
SC965 B
Print Start Error
During print processing, another command to start printing was
received.
Software bug
SC984 D
Print image data transfer error
After a data transfer begins from the controller to the engine via the
PCI bus, the transfer does not end within 15 s.
 Controller (SIMAC) board defective
 BICU defective
 BICU/controller disconnected
SC985 D
Scanned image data transmission error
After a data transfer begins from the engine to the controller via the
PCI bus, the transfer does not end within 3 s.
 Controller (SIMAC) board defective
 BICU defective
 BICU/controller disconnected