Service
Program
Mode Tables
1003 Registration Buckle Adjustment
Adjusts the registration motor timing. This timing determines the amount of
paper buckle at registration. (A higher setting causes more buckling.)
[–9 to +9/0/1 mm]
1 Tray LCT
2 Duplex Tray
3 By-pass Tray
4 Thick Paper Tray
5 Thick Paper Duplex Tray
1007 By-pass Feed Paper Size Display
Use this SP to confirm the size of the paper detected in the by-pass tray if
paper is skewing during feeding.
1008 Duplex Fence Adjustment
Adjusts the distance between front and rear fences. A smaller value shortens
the distance. If the fences are too far apart, skewing may occur in the duplex
tray. If the fences are too close, the paper may be creased in the duplex unit.
[–5 to +5/0/0.1 mm]
1102 Fusing Temperature Adjustment
Adjusts the temperature of the fusing units.
1
Duplex Actual Temperature
[0 to 1 /0/1]
2
Duplex Balance Temp (Center Thermistor)
[-30 to 0/-15/1]
3
Duplex Balance Temp (End Thermistor)
[-30 to 0/-15/1]
To Next Page
Loading...
