Service
Program
Mode Tables
7 Trailing Edge: Lc2r (Back)
Adjusts the area where the transfer current is applied for the trailing edge
during back side copying.
[0 to +20/0/1 mm]
8 On Timing: Lc2 (Back)
Adjusts the transfer current ON timing for back side copying.
[–30 to +30/20/1 mm]
9 On Timing: Thick Paper
Adjusts on transfer current ON timing for copying thick paper f.
[–30 to +30/0/1 mm]
10 Leading Edge: Thick Paper
Adjusts the area where the transfer current is applied for the leading edge
during copying with thick paper.
[0 to +20/0/1 mm]
11 Trailing Edge: Thick Paper
Adjusts the area where the transfer current is applied for the trailing edge
during copying with thick paper..
[0 to +20/0/1 mm]
12 Timing: Thick Paper Lc
Adjusts the transfer current OFF timing for copying thick paper.
[–30 to +30/15/1 mm]
13 On Timing: M-Thick
Adjusts the transfer current ON timing for copying with M-thick paper.
[–30 to +30/0/1 mm]
14 Leading Edge: M-Thick
Adjusts the area where the transfer current is applied for the leading edge
during copying with M-thick paper.
[0 to +20/0/1 mm]
To Next Page
Loading...
