Service
Program
Mode Tables
5114 Optional Counter I/F
This SP sets the machine for the MF Key Card Extension.
0: OFF, 1: ON
5118
Disable Copying
Temporarily denies access to the machine. Japan Only
[0 to 1/1]
0: Release for normal operation
1: Prohibit access to machine
5120
Mode Clear Opt. Counter Removal
Do not change. Japan Only
[0 to 2/ 0 / 1]
0: Yes. Normal reset
1: Standby. Resets before job start/after completion
2: No. Normally no reset
5121
Counter Up Timing SSP
Determines whether the optional key counter counts up at paper feed-in or at
paper exit.
[0 to 1/1]
0: Feed count, 1: No feed count
5126
Set F-size Document
Sets the original size that the machine detects for F sizes.
[0 to 2/1]
0: 8hf x 13
1: 8hf x 13qr
2: 8 x 13
Note: hf = 1/2, qr = 1/4
To Next Page
Loading...
