SP5000 Mode: SP5024 to SP5816
D131/D132/D133 3-118 SM Appendix
14 RCG Error Cause
Displays the cause of an RCG error. Where Cumin is used, normally displays
"0".
[0 to 1/0/1] 0:Normal condition 1:Error
If "1" is displayed, this means that the authentication from client to server failed
when the network re-booted. To restore normal operation, cycle the machine
off/on to return a "0" (normal condition).
21
RCG – C Registed
This SP displays the Embedded RC Gate installation end flag.
0: Installation not completed
1: Installation completed
22
RCG – C Regist Detail
This SP displays the Embedded RC Gate installation status.
0: RCG device not registered
1: RCG device registered
2: Device registered
23
Connect Type (N/M)
This SP displays and selects the Embedded RC Gate connection method.
[0 or 1 / 0 / 1 /step
0: Internet connection
1: Dial-up connection
61
Cert. Expire Timing DFU
Proximity of the expiration of the certification.
62
Use Proxy
This SP setting determines if the proxy server is used when the machine
communicates with the service center.
To Next Page
Loading...
