SP5000 Mode: SP5821 to SP5990
D131/D132/D133 3-130 SM Appendix
52 ECP (Centro)
Enables or disables ECP Compatibility.
[0 or 1 / 1 / 1 / step]
0: Disabled, 1: Enabled
Note: This SP is activated only when SP5-828-50 is set to "1".
65 Job Spooling
Enables/disables Job Spooling.
[0 or 1 / 0 / 1 / step]
0: Disabled, 1: Enabled
66 Job Spooling Clear: Start Time
Treatment of the job when a spooled job exists at power on.
0: ON (Data is cleared)
1: OFF (Automatically printed)
69 Job Spooling (Protocol)
Validates or invalidates the job spooling function for each protocol.
0: Validates
1: Invalidates
bit0: LPR
bit1: FTP
bit2: IPP
bit3: SMB
bit4: BMLinkS
bit5: DIPRINT
bit6: sftp
bit7: (Reserved)
87 @Remote Protocol Cnt
90 TELNET (0: OFF 1: ON)
Enables or disables the Telnet protocol.
[0 or 1 / 1 / – ]
0: Disable, 1: Enable
To Next Page
Loading...
