15. Change the position of the lower limit sensor [A] ( x 1).
16. Attach the harness (not shown) to the back of the plate and secure the sensor connector wire.
17. Attach the LCT cover [A] provided with the kit (
x 1).
18. Re-attach the right cover [B] (
x 2).
19. Connect the LCT to the machine.
20. Switch the machine on, enter the SP mode, then use SP5959 005 (Paper Size – Tray 4 (LCT)
to select the new paper size. For details, see SP5959 in "Service Tables".
To Next Page
Loading...
