Ricoh D131 - Page 868

Input/Output Check
SM Appendix 3-293 D131/D132/D133
Appendix:
Service
Program
Mode Tables
3.13.2 COPIER OUTPUT CHECK: SP5804
 Motors keep turning in this mode regardless of upper or lower limit sensor signals. To
prevent mechanical or electrical damage, do not keep an electrical component on for a
long time.
1. Open SP mode 5804.
2. Select the SP number that corresponds to the component you wish to check. (Refer to the
table on the next page.)
3. Press On then press Off to test the selected item.
 You cannot exit and close this display until you press off to switch off the output check
currently executing. Do not keep an electrical component switched on for a long time.
SP5804 Output Check Table
5804 Output Check
Turns on the electrical components individually for testing. This is the output
check for the main machine.
1
Feed Motor 1
2
Feed Motor 2
3
Feed Motor 3
4
Feed Motor 4
5
By-pass Feed Clutch
6
LCT Feed Motor
9
Pick-up SOL 1
10
Pick-up SOL 2
11
Pick-up SOL 3
12
Pick-up SOL 4
13
By-pass Pick-up SOL
14
LCT Pick-up SOL