Ricoh D131 - Page 972

D619 80 SM
Code Meaning Suggested Cause/Action
15-92 Memory Overflow  Transmission could not be received
because memory overflowed during the
transaction.
15-93 Memory Access Error  Transaction could not complete due to a
malfunction of SAF memory.
15-94 Incorrect ID Code  The machine rejected an incoming e-mail
for transfer request, because the ID code
in the incoming e-mail did not match the ID
code registered in the machine.
15-95 Transfer Station Function  The machine rejected an incoming e-mail
for transfer because the transfer function
was unavailable.
22-00 Original length exceeded the
maximum scan length
 Divide the original into more than one
page.
 Check the resolution used for scanning.
Lower the scan resolution if possible.
 Add optional page memory.
22-01 Memory overflow while
receiving
 Wait for the files in the queue to be sent.
 Delete unnecessary files from memory.
 Transfer the substitute reception files to an
another fax machine, if the machine’s
printer is busy or out of order.
 Add an optional SAF memory card or hard
disk.
22-02 Tx or RX job stalled due to
line disconnection at the other
end
 The job started normally but did not finish
normally; data may or may not have been
received fully.
 Restart the machine.
22-04 The machine cannot store
received data in the SAF
 Update the ROM
 Replace the FCU.
22-05 No G3 parameter confirmation
answer
 Defective FCU board or firmware.