Main SP Tables-3
D146/D147/D148/D149/D150 2-374 System Maintenance Section
Sets coefficient to decide Vtref correction value of Vtref correction by image
area.
Vtref correction value: SP3-222-009 to 012 = calculated Vtref correction value
large area coefficient (This SP)
How to use this SP: Vtref correction by image area.
021 High Coverage Coeff:K *ENG
[0.0 to 5.0 / 0.5 / 0.1/step]
022 High Coverage Coeff:C *ENG
023 High Coverage Coeff:M *ENG
024 High Coverage Coeff:Y *ENG
3232 [Vtref Correct:Pixel]
040
Initial ProCon Thresh *ENG [0 to 255 / 100 / 1times/step]
Executes Pro-Con by setting a Pro-Con flag when image area cumulative
average M (SP3-224-009 to 012) is larger than the specified value and then so
deciding that large area images are continuing. When large area images are
continuing, specified
041
High Coverage Thresh:H *ENG [0 to 100 / 100 / 1%/step]
How to use this SP: Refer to this SP when printing large area images.
When image area accumulate average M (SP3-224-009 to 012) is larger than
this SP, judges that high area images are continuing, then set Pro-Con flag and,
050
ProCon Thresh *ENG [0 to 255 / 100 / 1times/step]
Executes Pro-Con by setting a Pro-Con flag when image area total average M
(SP3-224-009 to 012) is larger than the specified value and then so deciding
that large area images are continuing. When large area images are continuing,
specified
060
Low Coverage Thresh *ENG [0.0 to 20.0 / 3.0 / 0.1%/step]
How to use this SP: Refer to this SP when printing small area images.
When image area accumulate average L (SP3-224-013 to 016) is less than this
SP, judges that low high area images are continuing, then temporarily dis
3232 [Vtref Correct:Pixel]
To Next Page
Loading...
