Ricoh D147 - Page 1094

Main SP Tables-3
System Maintenance Section 2-375 D146/D147/D148/D149/D150
SP Mode Tables
Switches to a mode able to call off Vtref lower limit (Upper limit of TC) by
deciding small area images are continuing when image area cumulative
average L (SP3-224-013 to 016) is small.
This SP
070 TC Upper Limit Correction *ENG [0.0 to 5.0 / 0.5 / 0.1wt%/step]
071 TC Upper Limit:Display:Bk *ENG
[1.0 to 15.0 / 8.5 / 0.1wt%/step]
072 TC Upper Limit:Display:C *ENG
073 TC Upper Limit:Display:M *ENG
074 TC Upper Limit:Display:Y *ENG
3233 [RTP Vtref Corr :Disp/Set]
001
ON/OFF
*ENG
[0 or 1 / 1 / 1/step]
0: OFF
1: ON
Controls ON/OFF the Vtref correction done based on RTP pattern deposit
amount during print.
3233
[RTP Vtref Corr :Disp/Set]
Sets Vtref correction value (K/C/M/Y) when RTP pattern deposit amount goes
over deposit amount threshold (upper/lower limit).
011 Corr Amt(+):K *ENG
[0.00 to 1.00 / 0.03 / 0.01V/step]
012 Corr Amt(+):C *ENG
013 Corr Amt(+):M *ENG
014 Corr Amt(+):Y *ENG
021 Corr Amt(-):K *ENG
022 Corr Amt(-):C *ENG
023 Corr Amt(-):M *ENG
024 Corr Amt(-):Y *ENG
3233 [RTP Vtref Corr :Disp/Set]