Printer SP Mode
D146/D147/D148/D149/D150 2-804 System Maintenance Section
1001 [Bit Switch]
009 Bit Switch 9 0 1
bit 0 PDL Auto Detection timeout of jobs
submitted via USB or Parallel Port (IEEE
1284).
Disabled
(Immediately)
Enabled
(10 seconds)
To be used if PDL auto-detection fails. A failure of PDL autodetection doesn't
necessarily mean that the job can't be printed. This bit switch tells the device
whether to time-out immediately (default) upon failure or to wait 10 seconds.
bit 1 DFU - -
bit 2 Job Cancel Disabled
(Not
cancelled)
Enabled
(Cancelled)
If this bit switch, all jobs will be cancelled after a jam occurs.
Note: If this bitsw is enabled, printing under the following conditions might
result in problems:
- Job submission via USB or Parallel Port
- Spool printing (WIM >Configuration > Device Settings > System)
bit 3 PCL/PS bypass tray paper rotation
(SEF/LEF)
Disabled Enabled
This bitsw causes the device to revert to the behavior of previous
generations. It only takes effect if "Bypass Tray Setting Priority" =
"Driver/Command".
Previous spec (bitsw=1): If a standard sized paper mismatch occurred in the
bypass tray, the MFP always prompted for SEF paper.
If this bitsw=0 (default) then in the event of a standard sized paper mismatch,
the MFP will always prompt for paper of the rotation (SEF/LEF) determined
by the MFP bypass tray paper setting or by the bypass tray sensor.
To Next Page
Loading...
