Printer SP Mode
System Maintenance Section 2-805 D146/D147/D148/D149/D150
bit 4 Timing of the PJL Status ReadBack (JOB
END) when printing multiple collated
copies.
Disable Enable
This bitsw determines the timing of the PJL USTATUS JOB END sent when
multiple collated copies are being printed.
0 (default): JOB END is sent by the device to the client after the first copy has
completed printing. This causes the page counter to be incremented after the
first copy and then again at the end of the job.
1: JOB END is sent by the device to the client after the last copy has finished
printing. This causes the page counter to be incremented at the end of each
job.
bit 5 Display UTF-8 text in the operation panel Enabled Disabled
Enabled (=0):
Text composed of UTF-8 characters can be displayed in the operation panel.
Disabled (=1):
UTF-8 characters cannot be displayed in the operation panel.
For example, job names are sometimes stored in the MIB using UTF-8
encoded characters. When these are displayed on the operation panel, they
will be garbled unless this BitSw is enabled (=0).
bit 6 Disable super option Enabled Disabled
Switches super option disable on / off. It this is On, multiple jobs are grouped
at LPR port. PJL settings are enabled even jobs that are specified queue
names are sent.
bit 7 Enable/Disable Print from USB/SD's
Preview function
Enabled Disabled
Determines whether Print from USB/SD will have the Preview function.
Enabled (=0): Print from USB/SD will have the Preview function.
Disabled (=1): Print from USB/SD will not have the Preview function.
To Next Page
Loading...
