Ricoh D147 - Page 1559

Input Check Table
D146/D147/D148/D149/D150 3-20 System Maintenance Section
021
Bottom Plate HP Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when bottom plate is not in home
position.
022
Bottom Plate Position Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when pick up roller is not in the
correct position.
023
Original Length 4 (LT/A4 Tail
Sensor)
ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor
area.
6123 [INPUT Check: 2K/3K FIN]
001
Entrance Sensor ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
002
Horizontal Transport Sensor ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
003
Switchback Transport Sensor ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
004
Proof Tray Exit Sensor ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
005
Shift Tray Exit Sensor ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
006
Booklet Stapler Exit Sensor ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
007
Paper Exit Open/Close Guide
HP Sensor
ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.