Ricoh D147 - Page 1558

Input Check Table
System Maintenance Section 3-19 D146/D147/D148/D149/D150
Input and Output
Check
008
Original Width 5 ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor
area.
009
Original Detection ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when original is set.
010
Separation Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor
area.
011
Skew Correction ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor
area.
012
Scan Entrance Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor
area.
013
Registration Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor
area.
014
Exit Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when there is a paper at sensor
area.
015
Feed Cover Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when cover is open.
016
Lift Up Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when lift up.
018
Pick-Up Roller HP Sensor ENG [0 or 1 / 0 / 1/step]
Gets sensor information from ADF. Gives 1 when pick up roller is not in home
position.