Ricoh D147 - Page 1564

Input Check Table
System Maintenance Section 3-25 D146/D147/D148/D149/D150
Input and Output
Check
050
Shift Tray Lower Limit Sensor
4
ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
051
Shift Tray Lower Limit Sensor
5
ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
052
Punch Chad Full Sensor ENG [0 or 1 / 0 / 1/step]
Gets information of specified sensor. Displays signal level of sensor as it is.
053
Punch Set Detection ENG
[0 or 1 / 0 / 1/step]
0: connected
1: not connected
Gets connection status of punch unit.
054
Shift Jogger Set Detection ENG
[0 or 1 / 0 / 1/step]
0: connected
1: not connected
Gets connection status of setting jogger unit.
* Not use: currently, VOLGA-B does not have setting jogger in system
configuration.
055
Booklet Stapler Set Detection ENG
[0 or 1 / 0 / 1/step]
0: not connected
1: connected
Gets connection status of saddle stitch unit.
056
Front Door SW ENG [0 or 1 / 0 / 1/step]
Gets information of specified switch. Displays signal level of switch as it is.
057
Dynamic Roller Open/Close
Guide Plate Sensor
ENG [0 or 1 / 0 / 1/step]
Gets information of specified switch. Displays signal level of switch as it is.
058
Tray Upper Limit SW ENG [0 or 1 / 0 / 1/step]
Gets information of specified switch. Displays signal level of switch as it is.