Ricoh D147 - Page 1832

D163 56 SM
Code Meaning Suggested Cause/Action
2-25 JBIG data reconstruction error
(BIH error)
 JBIG data error
 Check the sender’s JBIG function.
 Update the FCU ROM.
2-26 JBIG data reconstruction error
(Float marker error)
2-27 JBIG data reconstruction error
(End marker error)
2-28 JBIG data reconstruction error
(Timeout)
2-29 JBIG trailing edge maker error  FCU defective
 Check the destination device.
2-50 The machine resets itself for a
fatal FCU system error
 If this is frequent, update the ROM, or
replace the FCU.
2-51 The machine resets itself
because of a fatal
communication error
 If this is frequent, update the ROM, or
replace the FCU.
2-53 Snd msg() in the manual task
is an error because the
mailbox for the operation task
is full.
 The user did the same operation many
times, and this gave too much load to the
machine.
4-01 Line current was cut  Check the line connector.
 Check for line problems.
 Replace the FCU.
4-10 Communication failed
because of an ID Code
mismatch (Closed Network) or
Tel. No./CSI mismatch
(Protection against Wrong
Connections)
 Get the ID Codes the same and/or the
CSIs programmed correctly, then resend.
 The machine at the other end may be
defective.
5-00 Data reconstruction not
possible
Replace the FCU.
5-10 DCR timer expired  Replace the FCU.