D163 132 SM
3
Conditions required for Transfer
Result Report transmission
0: Always transmitted
1: Only transmitted if there was
an error
0: When acting as a Transfer Station, the
machine will always send a Transfer Result
Report back to the Requesting Station after
completing the Transfer Request, even if there
were no problems.
1: The machine will only send back a Transfer
Result Report if there were errors during
communication, meaning one or more of the
End Receivers could not be contacted.
4
Printout of the message when
acting as a Transfer Station
0: Disabled, 1: Enabled
When the machine is acting as a Transfer
Station, this bit determines whether the
machine prints the fax message coming in
from the Requesting Terminal.
5-7 Not used Do not change the settings.
Communication Switch 0C - Not used (do not change the settings)
Communication Switch 0D (SP No. 1-104-014)
No Function Comments
0-7
The available memory
threshold, below which ringing
detection (and therefore
reception into memory) is
disabled
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is
below this threshold, the machine cannot receive
any fax messages.
If this setting is kept at 0, the machine will detect
ringing signals and go into receive mode even if
there is no memory available. This will result in
communication failure.
To Next Page
Loading...
