Service Call 501-584
SM 5-55 D146/D147/D148/D149/D150
SC No. Level Error Name/Error Condition/Major Cause/Solution
§ Reset the paper
§ Remove the foreign matter
§ Replace the motor
§ Reset the connector
§ Replace the harness
§ Replace the sensor
§ Replace the control board for the optional paper feed tray
§ Replace the tray
§ Replace the paper feed roller
§ Replace the pick-up arm
SC No. Level Error Name/Error Condition/Major Cause/Solution
SC505-41 B Side LCIT Limit Detection Error
§ Upper limit detection error (during descent)
During tray initialization (upper limit detection/lower limit not
detected), the tray base plate is lowered to check the tray
base plate position, but the limit sensor is detected although
a predetermined time elapsed.
§ Upper limit detection error (during ascent)
During tray initialization (upper limit not detected /lower limit
detection), the tray base plate is raised to check the tray
base plate position, but the limit sensor is not detected
although a predetermined time elapsed.
*If an error occurs for 3 times consecutively: the side LCIT
transmits a "5th paper feed tray upper limit detection error"
to the main machine.
Up to 2 times consecutively, the side LCIT transmits a "tray
set fault" to the main machine.
To Next Page
Loading...
