Ricoh D147 - Page 804

Main SP Tables-1
System Maintenance Section 2-85 D146/D147/D148/D149/D150
SP Mode Tables
Do not change. Pressure setting welding pressure: thick paper 4:
163
Pressure:Special3:Low Speed *ENG [0 to 3 / 2 / 1/step]
Do not change. Pressure setting welding pressure: special paper 2: low speed
201
Filler Edge Detection Counter ENG [0 to 9000000 / 0 / 1/step]
Do not change. Times detecting filler edge
1152 [Fusing Nip Band Check]
001
Execute ENG [0 or 1 / 0 / 1/step]
Measure nip.
002
Pre-idling Time *ENG [0 to 999 / 300 / 1sec/step]
Do not change. Measuring fusing nip width before measure rotate time
003
Stop Time *ENG [0 to 100 / 20 / 1sec/step]
Do not change. Measuring fusing nip width stop time
004
Pressure Position *ENG [1 to 2 / 2 / 1/step]
Do not change. Measuring fusing nip width pressuring position
1153 [Abnormal Noise Confirmation]
001
Unit: Execute ENG [0 or 1 / 0 / 1/step]
Do not change. Abnormal sound check control (Mode not available)
003
Operation Line Speed ENG
[0 to 2 / 0 / 1/step]
0: Std Speed
1: Mid Speed
2: Low Speed
Do not change. Operating line speed of abnormal sound check control
004
Operation Time ENG [0 to 240 / 60 / 1sec/step]
Do not change. Operating time of abnormal sound check control
005 Heat Center Target Temp ENG [100 to 180 / 130 / 1deg/step]