Ricoh D147 - Page 805

Main SP Tables-1
D146/D147/D148/D149/D150 2-86 System Maintenance Section
Do not change. Heating center target temperature of abnormal sound check
control
006
Heat End Target Temp ENG [100 to 180 / 130 / 1deg/step]
Do not change. Heating edge target temperature of abnormal sound check
control
007
Press Target Temp ENG [0 to 200 / 0 / 1deg/step]
Do not change. Pressuring target temperature of abnormal sound check control
1154 [Switch:Rotation Start/Stop]
001
Judging Method Change *ENG
[0 or 1 / 0 / 1/step]
0: On
1: Off
Do not change. Switches Over heat prevent mode.
005
- *ENG [0 to 250 / 50 / 10msec/step]
Do not change. Heater On timing of start rotate/stop control
006
Overshoot Prevent Temp.:SC *ENG
[0 to 250 / D146:185, D147:185,
D148:195, D149:200, D150:200 /
1deg/step]
Do not change. Rotate start temperature of over heat prevent mode when error
occurs.
1155
[Small Size Paper Control]
Do not change. Small size heater control.
001 Print Width ENG [0 to 300 / 0 / 1mm/step]
1155
[Short Heater Control]
Do not change. Small size heater control.
011
Feed Permit
Temp.:delta:Center
ENG [0 to 200 / 5 / 1deg/step]