Installation
Option Installation
288 MagneMotion
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Align and Secure Rails to Spine Plates
Once all rails have been loosely attached to the spine plates, they must be aligned and secured
to the plates. The alignment sequence is:
1. Straight Rail to Curved Rail Joints
2. Curved Rail to Curved Rail Joints
3. Straight Rail to Straight Rail Joints
4. Curved Rail, No Joint Locations
5. Straight, No Joint Locations
Straight Rail to Curved Rail Joints
See Figure 5-35 when aligning and securing all straight rail to curve rail joints:
Figure 5-35: Tightening Sequence, Straight to Curve Precision Rail Spine Plate
1. Use fingers to align the end of the straight rail with the end of the curved rail.
NOTE: The jacking screws on the inside and outside end of the curved rail (see
Figure 5-33) are used for side to side alignment. Loosen the jacking screw on
one side of the rail and tighten the jacking screw on the other side of the rail
to align the two rail section.
2. Once the rails are aligned, tighten each screw to 1.8 N•m [16 in•lb] following the
sequence shown in Figure 5-35.
3. Repeat Step 1 through Step 2 for all straight rail to curved rail joints within the system.
1
1
2
2
3
3
Straight to Curve, Left Joint
Straight to Curve, Right Joint
M5 Screw
(4X)
To Next Page
Loading...
Need help?
General
