Installation
Facilities Connections
306 MagneMotion
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Light Stack Circuit
The MagneMover LITE transport system can use digital I/O, provided through a node control-
ler, for monitoring and control of local options such as a light stack. The optional light stack
circuit is the responsibility of the user and requires a user-supplied 3-color light stack and
+5…35V DC power supply (sized for the light stack) for the digital outputs. See the Node
Controller Hardware User Manual, MMI-UM013, for the digital I/O equivalent circuits. See
the MagneMover LITE Configurator User Manual, MMI-UM008, for information on config-
uring a light stack.
General Purpose Digital I/O
The MagneMover LITE transport system can use digital I/O, provided through a node control-
ler, to allow the host controller to monitor and control digital inputs and outputs, respectively.
See the Node Controller Hardware User Manual, MMI-UM013, for the digital I/O equivalent
circuits. See the Host Controller TCP/IP Communication Protocol User Manual,
MMI-UM003, or the Host Controller EtherNet/IP Communication Protocol User Manual,
MMI-UM004, for the command details for performing these operations.
To Next Page
Loading...
