Safety Guidelines
Electrical Hazards
64 MagneMotion
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
Electrical Hazards
The MagneMover LITE components are classified as extra-low voltage devices per IEC
60038, no additional safety precautions are required.
The power supplies, node controllers, network switches, and power modules are connected to
the AC Mains of the facility and can generate hazardous energy. The proper precautions for
operating and servicing electrical equipment must be observed. These precautions include fol-
lowing facility lockout/tagout procedures, and any other specified action within the facility
where the MM LITE components are being used.
SHOCK HAZARD
All electrical power to the MagneMover LITE transport sys-
tem must be disconnected per the facility lockout/tagout pro-
cedure before servicing to help prevent the risk of electrical
shock.
SHOCK HAZARD
Do not open any MagneMover LITE component to help pre-
vent the risk of electrical shock. Motors, controllers, and
other components do not contain any user-serviceable parts.
Do not turn on electrical power to the power supplies,
motors, and node controllers until after connecting all other
transport system components.
NOTICE To avoid equipment damage:
• Make sure that the transport system is properly grounded.
• When using custom vehicles or user-supplied rails, make
sure that all vehicles are grounded to the guideway
through conductive wheels or static brushes.
• Do not connect or disconnect any components while the
transport system has power.