Installation
Check-out and Power-up
312 MagneMotion
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
11. When using Ethernet motors:
A. Create a MICS file (see Ethernet Motor MICS File on page 97).
B. Upload the MICS file to all node controllers (see the Node Controller Interface
User Manual, MMI-UM001).
C. Cycle logic power to the motors to force the motors to request their network
provisioning.
12. Program the motors. See the Node Controller Interface User Manual, MMI-UM001,
for details.
Once programming is complete, any short flipper switches start the flipper homing
process (the flipper moves in and out – a series of slow moves then a series of rapid
moves).
13. Review the log files for each node controller to make sure that the system has been
programmed and configured properly (see the Node Controller Interface User Man-
ual, MMI-UM001).
To Next Page
Loading...
Need help?
General
