Introduction
MagneMover LITE Overview
40 MagneMotion
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
• Puck Body – Supports the magnet array and wheels and provides a mounting
surface for the payload.
• Septum/Septum Wheels – Provides guidance for the puck when moving
through switches.
• Lateral Guide Wheels – Provides guidance to make sure that the puck stays
centered in the track.
• Suspension Wheels – Provides a low friction support for the puck while mov-
ing.
• Side Bumpers – Provides protection for the bottom of the rails when carrying
unbalanced loads or when moving through curves at high velocity.
• Magnet Array – Interacts with the motors, which move the vehicle.
• UHMW Strip – Provides a low friction surface to help prevent damage if there
is contact between the magnet array and the motor.
• Switch (not shown) – One straight motor and one curve motor that are enclosed in one
module with an integral mechanical switching mechanism that provides either a merge
of two paths into one or one path that diverges into two.
• System Leg (Stand System) – Used to support the MagneMover LITE transport sys-
tem.
• V-brace – Used to align and secure adjacent sections of the guide rail to each other.
To Next Page
Loading...
Need help?
General
