EasyManuals Logo

Rockwell Automation MagneMotion MagneMover LITE User Manual

Rockwell Automation MagneMotion MagneMover LITE
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #438 background imageLoading...
Page #438 background image
Maintenance
Repair
438 MagneMotion
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
6. Remove the shims from the top of the magnet array and store them for reuse.
7. Locate the replacement magnet array and place flat on the work surface away from the
vehicle.
8. Place the previously removed shims on the top surface of the replacement magnet
array. Slide the shims around the array posts but do not allow the ends to extend
beyond the outer edges of the array.
NOTE: If the shims are removed, or additional shims added, the length of the screws
must be adjusted appropriately.
9. Place the mounting holes on the vehicle over the array posts. Realign the shims if nec-
essary to make sure that they align with the vehicle.
10. Secure the array to the vehicle with the two M4 x 12 mm screws that were removed in
Step 4 with Loctite 243 and tighten each screw to 1.5 N•m [13 in•lb].
The Loctite must cure for 2 hours at 22° C [72° F] before using the vehicle.
11. Replace the vehicle, see Replace Precision Rail Vehicles on page 428.
12. Restart the path.
13. Dispose of the removed magnet array appropriately.

Table of Contents

Other manuals for Rockwell Automation MagneMotion MagneMover LITE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rockwell Automation MagneMotion MagneMover LITE and is the answer not in the manual?

Rockwell Automation MagneMotion MagneMover LITE Specifications

General IconGeneral
BrandRockwell Automation
ModelMagneMotion MagneMover LITE
CategoryAccessories
LanguageEnglish

Related product manuals