Maintenance
Repair
MagneMover LITE User Manual 441
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
12. Place the mounting holes on the vehicle over the array posts. Realign the shims if nec-
essary to make sure that they align with the vehicle.
13. Secure the array to the vehicle with the four M4 x 12 mm screws that were removed in
Step 4 with Loctite 243 and tighten each screw to 1.5 N•m [13 in•lb].
The Loctite must cure for 2 hours at 22° C [72° F] before using the vehicle.
14. Replace the vehicle, see Replace Precision Rail Vehicles on page 428.
15. Restart the path.
16. Dispose of the removed magnet array appropriately.
To Next Page
Loading...
