Maintenance
Repair
MagneMover LITE User Manual 445
Rockwell Automation Publication MMI-UM002F-EN-P - October 2022
6. Insert the replacement concentric bearing from the bottom of the carriage.
7. Place the washer over the bearing post on top of the carriage.
NOTE: Make sure that all washers are placed on top of the carriage below the top
nut. Do not reassemble with washers on the underside of the carriage.
8. Thread the nut onto the bearing over the washer on top of the carriage.
9. Hold the bearing nut underneath the carriage in place with a 13 mm thin open ended
wrench. Use a 13 mm torque wrench to tighten the nut on the top of the carriage to
19 N•m [14 ft•lb] and apply Loctite 290.
The Loctite must cure for 3 hours at 22° C [72° F] before using the vehicle.
10. Repeat this procedure on the companion concentric bearing, if it is also being
replaced.
11. If eccentric bearings are to be replaced on this vehicle, see Replace Eccentric Bearings
on page 446.
12. If the vehicle is ready to be installed on the rail, see Replace Precision Rail Vehicles on
page 428.
To Next Page
Loading...
Need help?
General
