Fernsteuerbefehle
R&S
®
RTB2000
365Bedienhandbuch 1333.1611.03 ─ 05
SPECtrum:MARKer:RTABle:ENABle <ResultTable>
Shows the peak list.
Parameter:
<ResultTable> ON | OFF
*RST: OFF
SPECtrum:MARKer[:ENABle]
Enables the usage of markers.
Parameter:
<MarkerEnable> ON | OFF
SPECtrum:MARKer:SOURce
Defines the waveform type that is searched for peaks.
Parameter:
<Source> SPECtrum | MINHold | MAXHold | AVERage
*RST: SPEC
SPECtrum:MARKer:SETup:MMODe
Sets the mode for peak detection.
Parameter:
<MarkerMode> LONLy | ADVanced
LONLy
Level only: detects a peak when a certain minimum level is
exceeded. You can define the minimum level with SPECtrum:
MARKer:SETup:MLEVel.
ADVanced
Enables a more precise advanced peak definition.
SPECtrum:MARKer:SETup:MLEVel
Sets the minimum level for marker peak detection.
Parameter:
<MinimumLevel>
SPECtrum:MARKer:SETup:DISTance
Sets a distance between two subsequent peaks that has to be kept, for the peak to be
detected.
Anwendungen
To Next Page
Loading...
