Rohde & Schwarz RTB2004 - Page 396

Fernsteuerbefehle
R&S
®
RTB2000
396Bedienhandbuch 1333.1611.03 ─ 05
MMEMory:DATA <FileName>,<Data>
Writes data to the specified file in the current directory MMEMory:CDIRectory, or
reads the data.
Parameter:
<Data> 488.2 block data
The block begins with character '#'. The next digit is the length of
the length information, followed by this given number of digits
providing the number of bytes in the binary data attached.
Einstell- und Abfrageparameter:
<FileName> String parameter containing the file name
Beispiel:
MMEM:DATA "abc.txt", #216This is the file
#2: the length infomation has two digits
16: the binary data has 16 bytes.
MMEM:DATA? "abc.txt"
received: This is the file
Beispiel: Kapitel 15.2.1.2, "Einstellungsdaten speichern, kopieren und
laden", auf Seite 267
MMEMory:STORe:STATe <StateNumber>,<FileName>
Saves the current device settings to the specified file in the current directory.
Einstellparameter:
<StateNumber> Bereich: 1 bis 1
Inkrement: 0
*RST: 1
<FileName> String parameter
File name, with or without file extension
Beispiel:
MMEM:CDIR "/USB_FRONT/DATA"'
MMEM:STOR:STAT 1,"MORNING.SET"
Beispiel: Kapitel 15.2.1.2, "Einstellungsdaten speichern, kopieren und
laden", auf Seite 267
Verwendung: Nur Einstellung
MMEMory:LOAD:STATe <StateNumber>,<FileName>
Loads the device settings from the specified file in the current directory.
Einstellparameter:
<StateNumber> Bereich: 1 bis 1
Inkrement: 0
*RST: 1
<FileName> String parameter
File name, with or without file extension
Ergebnisse dokumentieren