Rohde & Schwarz RTB2004 - Page 427

Fernsteuerbefehle
R&S
®
RTB2000
427Bedienhandbuch 1333.1611.03 ─ 05
TRIGger:A:I2C:POFFset <PatternByteOffset>
Sets the number of bytes before the first byte of interest, relating to the end of the add-
ress bytes.
Parameter:
<PatternByteOffset> Number of ignored bytes
Bereich: 0 bis 4095
Inkrement: 1
*RST: 0
15.11.3.3
I²C-Decodierungsergebnisse
In allen BUS<b>:I2C...-Befehlen gibt das Suffix <b> den Bus an.
BUS<b>:I2C:FCOunt?....................................................................................................427
BUS<b>:I2C:FRAMe<n>:DATA?......................................................................................427
BUS<b>:I2C:FRAMe<n>:STATus?...................................................................................428
BUS<b>:I2C:FRAMe<n>:STARt?.....................................................................................428
BUS<b>:I2C:FRAMe<n>:STOP?..................................................................................... 428
BUS<b>:I2C:FRAMe<n>:AACCess?................................................................................429
BUS<b>:I2C:FRAMe<n>:ACCess?..................................................................................429
BUS<b>:I2C:FRAMe<n>:ACOMplete?............................................................................. 429
BUS<b>:I2C:FRAMe<n>:ADBStart?................................................................................ 430
BUS<b>:I2C:FRAMe<n>:ADDRess?................................................................................430
BUS<b>:I2C:FRAMe<n>:ADEVice?.................................................................................430
BUS<b>:I2C:FRAMe<n>:AMODe?.................................................................................. 431
BUS<b>:I2C:FRAMe<n>:ASTart?.................................................................................... 431
BUS<b>:I2C:FRAMe<n>:BCOunt?.................................................................................. 431
BUS<b>:I2C:FRAMe<n>:BYTE<o>:ACCess?................................................................... 432
BUS<b>:I2C:FRAMe<n>:BYTE<o>:ACKStart?................................................................. 432
BUS<b>:I2C:FRAMe<n>:BYTE<o>:COMPlete?................................................................432
BUS<b>:I2C:FRAMe<n>:BYTE<o>:STARt?......................................................................433
BUS<b>:I2C:FRAMe<n>:BYTE<o>:VALue?..................................................................... 433
BUS<b>:I2C:FCOunt?
Returns the number of received frames.
Suffix:
<b>
.
1 | 2
Rückgabewerte:
<FrameCount> Total number of decoded frames.
Verwendung: Nur Abfrage
BUS<b>:I2C:FRAMe<n>:DATA?
Returns the data words of the specified frame.
Analyse serieller Busse