Reference
Modification no.
- 0 -
Page
12
Date
1997 02 01
Main
914 F
01476
3) Introduction
We are pleased you decided for a ROTAX
®
aircraft engine.
Before carrying out maintenance work on the engine, carefully read the Maintenance Manual.
It provides you basic information on safe operation of the engine.
If any passages of the Manual are not understood or in case of any questions, please, contact
an authorized Distribution- or Service Partner for ROTAX
®
aircraft engines.
3.1) Remarks
This Maintenance Manual is to acquaint maintenance service staff approved by the
local aviation authorities with some basic maintenance and safety information for
service works.
For competent maintenance and servicing, please, refer to the documentation pro-
vided in the Operator's Manual, Installation Instructions and Spare Parts List.
For additional engine-, maintenance- and parts information you may also contact the
nearest ROTAX
®
aircraft engine distribution partner.
3.2) Engine serial number
On all enquiries or spare parts orders, always indicate the engine serial number, as the
manufacturer makes modifications to the engine for further development. The engine
serial number is on the top of the crankcase, magneto side (see Pic. 005).
4) Safety
Although the mere reading of such an instruction does not eliminate a hazard, the understand-
ing and application of the information will promote correct use.
The information and components-/system descriptions contained in this Maintenance Manual
are correct at the time of publication. ROTAX
®
, however, maintains a policy of continuous
improvement of its products without imposing upon itself any obligation to install them on its
products previously manufactured.
ROTAX
®
reserves the right at any time to discontinue or change specifications, designs,
features, models or equipment without incurring obligation.
The illustrations in this Maintenance Manual show the typical construction. They may not
represent in full detail or the exact shape of the parts which have the same or similar function.
Specifications are given in the SI metric system with the USA equivalent in parenthesis.
Where precise accuracy is not required, some conversions are rounded off for easier use.
To Next Page
Loading...
Need help?
General
