EasyManua.ls Logo

Rotax 914 F - 1) Fuel Filter; 2) Fuel Pumps

Rotax 914 F
274 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Reference
Modification no.
- 0 -
Page
33
Date
1997 02 01
Main
914 F
01476
9.2.1) Fuel filter:
The coarse filter installed in or next to the fuel tank has to retain coarse
fuel contamination. It must allow opening for cleaning.
In the feeding line between tank and inlet to the fuel pumps a fine filter is
located.
This filter is designed such that it can be inspected for maintenance. In
most cases this filter is part of a filter / water trap combination.
Filter has to be inspected at specified operating intervals. Clean or renew
filter as required.
The built-in filter on suction side of the electric fuel pump is not exchange-
able.
9.2.2) Fuel pumps:
To warrant safe and adequate operation of the fuel system two selfpriming
vane pumps are used. The voltage supply to the two pumps has to be
established completely independent.
NOTE: Voltage supply to main pump directly from internal genera-
tor and supply to the auxiliary fuel pump from bus bar or
battery.
For engine operation the rate of delivery of one pump only is
completely sufficient.
ATTENTION:Employ genuine ROTAX fuel pumps only, as the pump must
meet certain requirements.

Table of Contents

Other manuals for Rotax 914 F

Related product manuals