Scanlab RTC 5 PC Interface Board

To Next Page

To Previous Page

RTC

5 PC Interface Board

Rev. 1.9 e

10 Commands And Functions

279

innovators for industry

Ctrl Command get_standby

Function returns the currently set standby parameters.

Call

get_standby( &HalfPeriod, &PulseLength )

Returned

parameter

values

HalfPeriod

half of the currently set standby output period of the standby pulses as a

pointer to an unsigned 32-bit value (1 bit equals 1/64 µs).

PulseLength

currently set pulse length of the standby pulses as a pointer to an

unsigned 32-bit value (1 bit equals 1/64 µs).

Comments • For usage of this command, see page 129.

RTC



RTC

5 new command

In RTC

4 compatibility mode, the RTC

5 divides the parameter values by 8 (1 bit equals

1/8 µs).

Version info Available beginning with version DLL 515, OUT 514, RBF 512

References set_standby

Scanlab RTC 5 PC Interface Board - get_standby