Scanlab RTC 5 PC Interface Board - 18 Revision History

RTC
®
5 PC Interface Board
Rev. 1.9 e
18 Revision History
605
innovators for industry
18 Revision History
This list ignores spelling/grammar corrections, syntax reformulations or additions (such as new cross-refer-
ences) that don’t affect the technical meaning. The supplied page numbers refer to this document.
Changes from revision 0.9 to revision 0.11
Page Name of section / command Change
22 chapter 1.2 "Identification" ID number is not written on the board
44 chapter 4.3.3 "Data Cable (Optional)" Recommend cable impedance added
120 chapter 7.3.3 "Virtual Image Field" Chapter added
(also usage for coordinate transformations)
200 chapter 8.11.3 "Determining
Reference Values"
Reference values for automatic self calibration are stored in
DLL or EEPROM
210 External List Start Information on master/slave synchronization with external
start and activated home jump
217 Normal, Short and Variable List
Commands and List Multi-
Commands
Expanded information on short list commands
236 auto_cal command Reference values for automatic self calibration are stored in
DLL or EEPROM
322 list_nop command New comment
407 set_auto_laser_control command Corrected: return value (error code) 5
415 set_delay_mode command Corrected: RTC
®
4 compatibility mode
420 set_end_of_list command Corrected: comments
469 set_port_default command Corrected: comments
574 chapter 15 "Appendix A: The
RTC
®
5 PC/104-Plus Board"
Chapter added