Scanlab RTC 5 PC Interface Board - set_softstart_level_list

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
485
innovators for industry
Normal
List Command
set_softstart_level_list
Function similar to set_softstart_level (see above), but a list command
Call
set_softstart_level_list( Index, Level1, Level2, Level3 )
Parameters See set_softstart_level.
Comments • The set_softstart_level command defines three
Level values for the pulses number
Index through Index+3 . The command must be called separately for each individual
Level1/2/3 value-triple.
•
Index must be in the range [0…1023], otherwise the set_softstart_level_list
command will, already during loading, be replaced by a list_nop (get_last_error return
code
RTC5_PARAM_ERROR ).
• Softstart won’t use level values where the index count exceeds
Number ( Number is spec-
ified via set_softstart_mode).
• Otherwise this command is identical to the control command set_softstart_level (also
see the comments there).
• If the “freely defined wobbel shape“ wobbel mode is activated, then this command will
have no effect; see chapter 8.4 "Wobbel Mode", page 167.
RTC
®
4  RTC
®
5new command
In RTC
®
4 compatibility mode: see set_softstart_level
Version info Available as of version DLL 536, OUT 536
References set_softstart_level, set_softstart_mode, set_softstart_mode_list