RTC
®
5 PC Interface Board
Rev. 1.9 e
16 Appendix B: The RTC
®
5-Express Board
592
16.1.4 Identification
The serial number of the RTC
®
5-Express board is
printed on a white label attached to the board
(format: “RTC SN…”).
The board’s ID number and configuration are
described in the packaging list (also see "Optional
Accessories", page 29 and "Type Identification", page
575).
16.1.5 Type Identification
The ID number of the RTC
®
5-Express board reveals
the board’s factory-equipped jumper configuration
(JP1-JP8). The jumper configuration is additionally
encoded in a three-digit type code scheme. The type
code scheme is identical to that of the
RTC
®
5 PC interface board (see page 28).
16.1.6 Unpacking Instructions and
Typical Package Contents
Carefully remove the RTC
®
5-Express board from
the package.
Keep the packaging, including the antistatic bag
the RTC
®
5-Express board is delivered in, so that in
case of repair the board can be properly
repackaged and returned to SCANLAB.
Also remove all other articles from the package.
Check that all parts have been delivered. Refer to
the corresponding packaging list.
The package typically includes an RTC
®
5-Express
board and a data CD (containing the corre-
sponding software (see below) and this manual).
Some product versions may also supply
additional components such as data cables or
converters (see "Optional Accessories", page 576).
Delivered Software
The delivered software package is identical to the
RTC
®
5 software package (see page 23). It contains
software drivers for Microsoft’s WINDOWS 8,
WINDOWS 7, WINDOWS Vista and WINDOWS XP
(SP2 or higher) (32-bit or 64-bit) operating systems,
correction, DLL and program files, as well as utility
files for C, C++ and C#.
16.1.7 Optional Accessories
In addition to the RTC
®
5-Express board and its
software package, the following accessories – as with
the RTC
®
5 PC interface board – can be obtained from
SCANLAB (only hardware extensions from SCANLAB
should be used in combination with the RTC
®
5-
Express board):
• XY2-100 converter (see page 29).
• Data cables (see page 29).
• Laser adapter (see page 29).
• Slot cover with a 9-pin D-SUB connector for using
the 2. SCAN HEAD connector (see page 42).
• Slot cover with a 15-pin D-SUB connector for
using the MARKING ON THE FLY connector (see
page 51).
16.1.8 Supplementary Software
For customizing RTC
®
correction files on the basis of
test measurements, SCANLAB offers the correXion5
program and its associated manual (also see
page 121).
To Next Page
Loading...