Scanlab RTC 5 PC Interface Board - load_jump_table

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
334
innovators for industry
Control
Command
load_jump_table
Function loads a value table with jump delay data points from an ASCII text file (or alternatively
performs automatic determination on the attached scan system) and uses linear
interpolation to create the internal jump delay table for 2D jumps executable in jump
mode.
Call
NoOfDataPoints = load_jump_table( Name, No, PosAck, MinDelay, MaxDelay, ListPos )
Parameters Name See load_jump_table_offset.
No See load_jump_table_offset.
PosAck See load_jump_table_offset.
MinDelay See load_jump_table_offset.
MaxDelay See load_jump_table_offset.
ListPos See load_jump_table_offset.
Return See load_jump_table_offset.
Notes • The command is identical to load_jump_table_offset with
Offset = 0.
Version info Available beginning with version DLL 525
RTC
®
4  RTC
®
5new command
Reference load_jump_table_offset