Scanlab RTC 5 PC Interface Board - set_free_variable; set_free_variable_list

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
433
innovators for industry
Ctrl Command set_free_variable
Function sets a free variable to the desired value.
Call
set_free_variable( No, Value )
Parameters No Number of the free variable to be set as an unsigned 32-bit value.
Allowed range: [0 … 3]
Only the two least significant bits are evaluated.
Value Desired variable value as an unsigned 32-bit value.
Allowed range: [0 … (2
32
–1)]
Comments • See chapter 6.9.1 "Free Variables", page 92.
RTC
®
4  RTC
®
5new command
Version info Available beginning with version DLL 531, OUT 532
References set_free_variable_list, get_free_variable, set_trigger
Undelayed
Short
List Command
set_free_variable_list
Function same as set_free_variable (see above), but a list command
Call
set_free_variable_list( No, Value )
Parameters No See set_free_variable.
Value See set_free_variable.
Comments • See set_free_variable.
RTC
®
4  RTC
®
5new command
Version info Available beginning with version DLL 531, OUT 532
References set_free_variable