Scanlab RTC 5 PC Interface Board - stepper_enable_list

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
517
innovators for industry
Undelayed
Short
List Command
stepper_enable_list
Function same as stepper_enable (see above), but a list command and without a return value
Call
stepper_enable_list( Enable1, Enable2 )
Parameters Enable1,
Enable2
See stepper_enable.
Comments • See stepper_enable.
RTC
®
4  RTC
®
5 new command
Version info • Available beginning with version DLL 527, OUT 529, RBF 519
• For older RTC
®
5 boards with DSP version numbers < 2 (get_rtc_version bits #16-23),
the command is neither executed nor replaced by list_nop (get_last_error return code:
RTC5_TYPE_REJECTED ).
References stepper_enable