Scanlab RTC 5 PC Interface Board - set_softstart_mode

To Next Page

To Previous Page

RTC

5 PC Interface Board

Rev. 1.9 e

10 Commands And Functions

487

innovators for industry

Variable

List Command

set_softstart_mode_list

Function same as set_softstart_mode (see above), but a list command

Call

set_softstart_mode_list( Mode, Number, Delay )

Parameters See set_softstart_mode.

Comments • set_softstart_mode_list switches off the “laser active” laser control signals by

executing list_nop and waits until the LaserOff delay has expired.

• Otherwise this command is identical to the control command set_softstart_mode (also

see the comments there).

RTC



RTC

5new command

Version info Available as of version DLL 536, OUT 536

References set_softstart_mode, set_softstart_level, set_softstart_level_list

Scanlab RTC 5 PC Interface Board - set_softstart_mode_list