Scanlab RTC 5 PC Interface Board - set_mcbsp_in_list

RTC
®
5 PC Interface Board
Rev. 1.9 e
10 Commands And Functions
453
innovators for industry
References set_mcbsp_in_list
Undelayed
Short
List Command
set_mcbsp_in_list
Function identical with set_mcbsp_in (see above), but a list command
Restriction If the Processing-on-the-fly option is not enabled, then the command terminates the
Processing-on-the-fly process (even though it couldn’t have been activated).
Call
set_mcbsp_in_list( Mode, Scale )
Parameters Mode See set_mcbsp_in.
Scale See set_mcbsp_in.
Comments • If
Mode > 5, then set_mcbsp_in_list will be replaced by a list_nop (get_last_error
return code
RTC5_PARAM_ERROR ).
• See set_mcbsp_in.
RTC
®
4  RTC
®
5new command
Version info Available beginning with version DLL 531, OUT 532
References set_mcbsp_in
Ctrl Command set_mcbsp_in