VISOR
®
Communications manual
After the command is sent, the /tmp/ on the VISOR
®
vision sensor will be checked for a valid
firmware file. The name must correspond to the typical name allocation (e.g. as after the
download from the SensoPart homepage). The end is reached as soon as the camera signals
ready (pin 4 GN) again. Alternatively, the telegram "GSI1" can be used to check whether a valid
response is being sent.
NOTE:
The voltage supply must be ensured during the firmware update. An update may
take up to 10 minutes.
06814859 - 1/24/2019-00 Page 168 EN
To Next Page
Loading...
